My Field Bag

is empty

Cemetery Lot Markers

Prices
$6.14
11 - 24
$4.46
25 - 99
$2.90
100 - 249
$2.80
250 or more
Prices
$6.14
11 - 24
$4.46
25 - 99
$2.90
100 - 249
$2.80
250 or more
Prices
$8.66
11 - 24
$5.52
25 - 99
$5.15
100 - 249
$4.82
250 or more
Prices
$8.66
11 - 24
$5.52
25 - 99
$5.15
100 - 249
$4.82
250 or more
Prices
$7.83
25 - 99
$7.00
100 - 295
$6.18
300 or more

Cemetery Markers for Rebar - To identify Cemetery Lots & Blocks

Berntsen cemetery markers come with an imprint suitable for use in cemeteries.  Berntsen Cemetery Lot Markers are available in 2" and 3 ¼"  diameters.  They fit 1/2" or 5/8" rebar as the SureGrip plastic insulator holds the cap tightly to the rebar and virtually eliminates dissimilar metal corrosion.   Orbital forged from 6000 aluminum so they won't crack or break, yet soft enough to punch numbers easily in the field with our stamp sets.

 Cemetery EcoStake

EcoStake - Exclusively from BerntsenRecycled plastic EcoStake for marking cemetery blocks & lots

The Berntsen EcoStake is made of recycled plastic and is UV protected.  It will not rot, splinter or split and is not subject to insect damage.  Each EcoStake contains a magnet in the top that makes later location a snap.  The plastic top is imprinted with a four quadrant cross to stamp your Lot & Block numbers.

Cemetery Lot Markers from Berntsen

Thank you for choosing Berntsen cemetery markers for rebar.  For over 40 years Berntsen has worked to continuously improve and develop our products and service to exceed your needs. Exclusive features of our metal cemetery markers & rebar caps include:

  • Super-tough, cold forged, aluminum alloy that will not bend or break
  • SureGripT plastic insulator that makes removal from the rebar nearly impossible and protects the cap from dissimilar metal corrosion
  • Cemetery markers can be customized with text, numbers & center marks.


How to install Berntsen Cemetery Markers

Cemetery Lot Marker Installation InstructionsTools: Berntsen suggests these tools to help with your installation.

Pre-Installation: Save time in the field with a little preparation in your shop.

  • Cut your rebar to the desired length using a hacksaw or power press.
  • Remove any burrs and/or mushrooming on the end that will be receiving the cemetery marker
  • For maximum grip, bevel the end of the rebar that will be receiving the cemetery marker

Installing the Rebar:
With a felt-tip permanent marker, place a mark about 1½" from the end of the rebar.  This mark will be your guide to assure the cap is tightly and completely seated on the rebar.

Drive your rebar to the desired depth.  Remember to leave enough rebar to install the cemetry marker.

Installing the Cemetery Lot Marker:
To restrict any "sinking" of the rebar into the ground when applying the survey marker, clamp a vice-grip pliers to the rebar at ground level.  The handle of the pliers will prevent the rebar from sinking into the soil as you drive on the cemetery cap.

Some pre-install the cemetery marker onto the rebar prior to entering the field and then drive the rebar and marker assembly with a dead-blow hammer.

Once you have your rebar and cap to the desired depth your installation is complete.


Berntsen Survey Markers Installation Instructions Video

We accept VISA, Master Card, American Express and Discover Card.